b'Additional building wrap with 75mm cover tohead flashing.Timber wall framing with wall insulation as allspecified by Architect. Selected profiled exterior metal sheet150 upstandcladding on 20mm H3.1 vertical timber battensBuilding wrap to return into louvre opening. to Architects specification.Provide flashing tape over wrap as per WANZwindow installation system. uPVC vent strip.Head trimmer or lintel as required to span 15mm cover to claddingopening. 5 20mm min cover to joinery40 x 25 x 3 fixing angle pop rivited to back of Inseal tape between joinery and flashing.frame @ 300mm c/c. Fix to platewith wood screws @ 300mm c/c. Purpose made head flashing with 15 slope toOsbournes Model WPL50 (Flanged). extend 150mm behind cladding. Provide 20mmmin cover to head of louvre with drip edge andstop ends.Model WPL 50 (Flanged Frame)Typical Horizontal Corrugate/Louvre Head Detail 01 Osbournes LtdScale 1:5Close end of flashing and scribe to suit cladding Selected profiled exterior metal sheetprofile. cladding on 20mm H3.1 vertical timber battensTimber wall framing with wall insulation as all to Architects specification.specified by Architect.Compressible foam. 50mm min coverPreformed jamb flashing. 5 535mm H3.1 treated packer to stop above sill 50mm mintrimmer to allow sill flashing to finish hard 15mm min cover to flashingagainst trimmer stud.Building wrap to return into louvre opening. 3108 Inseal tape 12mm thick x 10mm wide.Provide flashing tape over wrap as per WANZ Osbournes Model WPL50 (Flanged).window installation system.40 x 25 x 3 fixing angle pop rivited to back of Line of sill flashing under.frame @ 300mm c/c. Fix to plate Line of head flashing.with wood screws @ 300mm c/c.Model WPL 50 (Flanged Frame)Typical Horizontal Corrugate/Louvre Jamb Detail 02Osbournes LtdScale 1:5Page 8'