b'Osbournes Model WPL 80 (Flanged).40 x 40 x 3 fixing angle pop rivited to back offrame @ 300mm c/c. Fix to platewith wood screws @ 300mm c/c. Aluminium sill flashing with 50mm min cover tocladding. Provide 5slope to exterior with hem toback edge and 20mm min upstand at both ends.Sloped sill trimmer to suit.50mm cover to claddingBuilding wrap to return into louvre opening.Provide flashing tape over wrap as per WANZ 5 gap without sealwindow installation system.Selected fibre cement cladding as specified byTimber wall framing with wall insulation as Architect on 20mm H3.1 vertical battens to formspecified by Architect. cavity. Fix in accordance with manufacturersrecommendations.Model WPL 80 (Flanged Frame)Typical Fibre Cement/Louvre Sill Detail 03 Osbournes LtdScale 1:5General Notes:Flashing materials must be selected based on environmental exposure, refer to NZS 3604:1999.Building wrap must comply with acceptable solution E2/AS1 & NZS 3604:1999.Flashing tape must have proven compatibility with the selected building wrap & other materials with which it comes into contact.Refer to the manufacturer or supplier for technical information of all materials.This is an untested alternative solution to NZBC E2/AS1.This information is intended to be informative and used as a guideline only. Due to the many variables affecting different projectsOsbournes Ltd can not replace the judgment or advice of an Architect, Engineer or any other relevanttechnical expert and such experts must be consulted to determine the suitability or otherwise of the details or the necessity forfurther design/detailing.Page 16'