b'Osbournes Model WPL100 (Flanged). Line of jamb flashing.40 x 40 x 3 fixing angle pop rivited to back of Provide sill flashing with 10slope to exterior &frame @ 300mm c/c. Fix to plate hem to back edge with 20mm min upstand atwith wood screws @ 300mm c/c. both ends . Provide 25mm cover min to flashing.Flashing to cover at least one corrugation.Sloped sill trimmer to suit. 25mm cover to flashingBuilding wrap to return into louvre opening. 5 Close end of flashing and scribe to suit cladding5Provide flashing tape over wrap as per WANZ profile. Pop rivit to cladding.window installation system.Timber wall framing with wall insulation as Selected profiled exterior metal sheetspecified by Architect. cladding on 20mm H3.1 vertical timber battensto Architects specification.Model WPL 100 (Flanged Frame)Typical Horizontal Corrugate/Louvre Sill Detail 03 Osbournes LtdScale 1:5General Notes:Flashing materials must be selected based on environmental exposure, refer to NZS 3604:1999.Building wrap must comply with acceptable solution NZBC E2/AS1 & NZS 3604:1999.Flashing tape must have proven compatibility with the selected building wrap & other materials with which it comes into contact.Refer to the manufacturer or supplier for technical information of all materials.This is an untested alternative solution to NZBC E2/AS1.This information is intended to be informative and used as a guideline only. Due to the many variables affecting different projectsOsbournes Ltd can not replace the judgment or advice of an Architect, Engineer or any other relevanttechnical expert and such experts must be consulted to determine the suitability or otherwise of the details or the necessity forfurther design/detailing.Page 31'